Our lovely Nissan 300ZX is almost finished. We’re just waiting on an Alternator Belt to arrive, which we will fit once its arrived.
We solved the running issues which we originally thought were linked to the cold start motor but were in fact linked to the air filter taking in too much air. Once the alternator belt has been fitted, one of the technicians will take the Nissan for a spin to see how it runs and as long as it passes its road test without any snags, it’ll be sent up to our hanger to be stored until the owner is ready to pick it up.
We discovered what seems to be a wiring issue in the engine of our 1988 Nissan 300ZX. After taking an intensive look, Ady diagnosed the problem to possibly be a cold starting issue with the choke. Although this is situated in the engine, it’s more of an electrics issue.
More news to follow!
Our trim team has been fitting the rear centre section in place, cutting out sound deadening and glueing it to bodywork behind where seats go.
The rear squab section has also been fitted in place, the carpet has been cut to be placed in front of the rear seat base, the rear seat section has been fitted in place, and the leather has been glued to the seat subframes.
Sound deadening has been installed in the rear footwell & tunnel sides, passenger side, passenger side bulkhead, and the front footwells.
The door frames are also undergoing some modifications so that the window glass sits more comfortably. The doors will need to be taken apart and re-welded back together.
Our Peony Red 1960 Jensen 541s has had new door catch fixing plates installed. Our technicians have also made a cover to go over them to stop them from falling down into the sills of the car. They have then been welded into position.
The Triumph TR6 is on the road to recovery with the final tweaks being done. The engine levels have been checked as have the gearbox and rear axels. This stage is mostly a pre-drive service to make sure everything is in the right place and ready for the car to be driven for the first time. The battery holder needs to be installed and the engine to be tuned. Once these last details are done we can turn it on and see how it drives and address any teething problems that may arise.
The Amphicar is currently going through another in-depth stage of troubleshooting the electrics. Much like the TR6, our technicians’ are applying the final checks in preparation for starting the car up for the first time.
The Peugeot 504 is almost finished! The exhaust and break lines have been installed as well as the seat belts which have been added by our technician Scott.
The black 1960 Jensen 541R has come out of paintwork recently to address the corrections made. All the chrome has now been re-installed so it’s looking shiny and new!
Our Lada is one of our most recent patients. We diagnosed it with rusting sills and floor, which is being addressed and corrected by one of our fabricators, Ant. These refurbishments are done through a series of stages that include welding and applying filler to resolve the ageing. Think of it like getting a dermatological facial!
Our blue jaguar e-type is awaiting its chrome bumper and new steering rack to be fitted. The sun roof has also been fixed. This included taking apart the faulty switch and cleaning the components and then insulating the terminal. Once fitted back together, the sun roof was back to working perfectly again.
Our gold and red 1962 Jensen 541S has had its oil changed and water purged from the engine by our engine specialist, Ady.
Ady is also working on the Austin 7 Nippy engine which is currently at COLTEC to be assessed.
The exhaust has been reinstalled into our Nissan as well as the link pipe between the two exhaust manifolds.
The Nissan is on the home straight in its restoration journey. It should be done before Christmas all being well!
It has just had its wheels refurbished, new wing mirrors, a thorough clean by Viper Auto Valets, the exhaust manifolds replaced to solve the leak as well as new exhaust studs. The next step is to piece it all back together and get it checked over for a final service.
There’s been a lot going with week already and its only Wednesday! Take a look at what’s been going on s far.
One of our directors, Gordon, had his Range Rover Sport’s tyres refurbished, ready for the cold winter months ahead. Now fully refurbished, Gordon’s Range Rover is ready to take on the elements.
As seen in our blog yesterday, the 1967 Jaguar E-Type Race Car has now been finished! This has been an incredibly exciting project that has been in progress since 2016. Over the last few days, the finishing touches have been added such as the pinstripes on the bonnet and fine-tuning the engine. The bonnet itself has also be re-installed to make sure it fits after the recent engine works.
Our other director, Craig, is in the process of choosing the leather for the interior and the spray finish for the fuel tank. It’s deciding details like this that make classic cars so personal to their owners.
One of the more notable updates on the Morris Minor 1000 is the new hood. The trim shop has done a fantastic job yet again to make the perfect custom hood, allowing this Morris Minor to be more usable throughout the changing seasons. Our technician Scott has also been trying to figure out the reason for the play in its front wheels. The mystery is yet to be solved…
The front suspension has also been tightened, the curtesy light wiring is being installed and Adam is troubleshooting the electrics.
Lots of little updates for the Grey Jensen 541R such as preparing the door rim before it goes to the trim shop, stripping the bonnet ready for paint, made the curtesy light switch by hand, installed the hand brake cables and panhard rod as well as the speedo drive.
Our 1968 Triumph TR5 is awaiting its interior but it has had its heater installed!
Our blue 1973 Jaguar E-Type Series 3 is awaiting on a new steering rack, clutch slave cylinder and bumper to be fitted. The parts have been ordered so the E-Type should be looking good as new in no time!
This lovely 1953 Ford Transit is almost ready to leave us now. We’re just waiting on some new 6 volt bulbs for the headlights and then it’ll be ready to go!
We’re giving the blue Jensen a general nut and bolt service. It came in to have its clutch, exhaust and breaks replaced which have been or are in the process of being fixed.
The Peony Red Jensen 542S has had its seats made up. The next step is to complete the set and install them. Our trim shop never fails to impress us with their stunning interior projects.
The Peugeot 504 has now had all its interior trim completed. The last few pieces include making and fitting the hood which had to have the leather glued to the frame once made up.
The black Jensen is visiting our paint shop for some touch-ups and corrections in the paintwork.
Ady our engine specialist has taken apart both exhaust manifolds on the Nissan 300ZX.
The fuel pump has been rewired, two bilge pumps are set to be added, the brakes have been bled, the grease nipples re-greased and the heater has been ordered.
A new gear stick gaiter has been made and fitted by the trim shop. Our range rover is making steady progress to be completed soon.
Although we don’t have the Black Spitfire back with us, we do have the task of replacing the half shafts. We’re hoping we can order in new pieces however we may need to take these apart instead and refurbish them ourselves.
As ever, it’s been a busy week here at Bridge Classics. We’ve had new cars arrive like the Mini Clubman, we’ve had a new winner announced yesterday and lots of new developments with our current projects. Here’s what’s gone on throughout the week!
Our engine specialist Ady has been working on the 504’s engine by fitting the flywheel and couch before fitting it back into the Peugeot.
The Peugeot has also had a recent trim shop appointment, with new carpets being made and fitted by our expert, Brian.
The Black Jensen has had new sills made and fitted to give the finishing touch to the bottom of its driver’s door.
The Nissan Micra has now been finished! The paintwork has been completed, bumps and scrapes were taken out and it’s pretty much ready to go again! This endearing little Micra would make the perfect first car for someone learning to drive!
The Nissan 300ZX has come in recently and appears to have some rather severe rust issues on the lower door sills. Among other restorations, that rust and those holes will have to go! You can see the rest of the work here.
One of our technicians, Scott has been working carefully on the Morris Minor’s dazzling red interior. The door cards, handles, and carpets have all been fitted.
This Jensen actually belongs to Bridge’s director and founder, Gordon Ranson, and is now starting its restoration journey with us! There’s a lot to do but we can’t wait to see the final product!
One of our technicians Anthony has been working on the body, hand making a lot of the elements such as the boot floor.
Barn finds are like hidden treasures and we love them when they come in. Currently, we’ve got two prospective projects that need cleaning up and assessing before we know what needs to be done. We really hope we’ll be able to work on these two cars!
This Austen Healey 100 BN1 is currently residing in America but could be ours soon! Keep an eye out on our website and social media pages for updates!
When you work with classic cars all the time, sometimes you want to mix it up a bit. That’s exactly what our Director Craig has done! He’s recently acquired this 3 litre speed boat. Fingers crossed for nice weather soon then!
Another prospective project has been viewed recently and it’s a beautiful red e-type that needs some TLC!
Pete, one of Bridge Classic Cars’ vehicle technicians has been working on our Nissan 300zx restoration. He has replaced the faulty water pump. He is also giving the engine a full service including new cam belt, spark plugs, fuel filter, oil filter and fresh oil.
Great work, Pete
The next job for Paul and Chris to tackle is the wing mirrors of our Nissan 300ZX.
Paul removed the damaged wing mirrors from the vehicle and has passed them over to Chris in the Paint shop.
Chris firstly prepared the mirrors for paint, repairing the damage. He’s masked up the glass, rubbed them down, filled with filler, rubbed down filler and then applied primer.
Chris then gave the primed mirrors one more thorough rub down, ensuring the surface is perfect before paint.
He then applied the colour coat and top coat lacquer. Great work!
The mirrors will now head back to Paul to be installed into the vehicle.
This late 80’s Japanese sports car is being put back on the road and needs a bit of love to get her ship-shape.
Paul has been tasked with undertaking the restoration of this lovely vehicle.
The 300ZX’s rear brake calliper has a very corroded piston and bore. Both the rear and front brakes are showing significant corrosion and are in need of a complete overhaul.
The shock inserts needed replacing so we’ve sourced and installed new. The alloy wheels have been professionally refinished and treated to fresh new rubber. They look absolutely stunning and work perfectly with the styling of this 300ZX.
Paul has discovered the source fo the coolant leak. The top hose connector has corroded (pictured below). This will need replacing with new.
We have started to work on recommissioning our Nissan 300ZX and get it ready for an upcoming MOT. The brakes caliper pistons are seized due to a seal on each being split. These will need to be overhauled as part of the recommission. The springs need to be replaced with new but at present we can only source 1 of 2 required. A lot of suppliers are still away from work so hopefully we can track down another soon. The top hoses have crystallised inside and this has been caused by the joint (pictured) having corroded over the years.
The latest addition into our Classic Car Workshop is this lovely 1988 Nissan 300ZX. We’ve been tasked with getting the vehicle up to MOT standards and tidying up the exterior paintwork.