Finished TVR Hood and a General Tidy-Up.

By Craig Ranson
By Craig Ranson

Managing Director – Bridge Classic Cars

Kath has now finished repairing the hood on the 1989 TVR SII 2.9 V6. In the last blog post, we heard about how she was removing the old PVC window out of the hood, because of it becoming delaminated and coming out of the seam at the corners. She used the original as a pattern to mark out around and cut out on a sheet of new clear PVC. Once cut out, Kath applied contact adhesive to the outside edge of the PVC and slotted it in between the layers of hood fabric at the seam edge and left it to dry. She could then sew down the same lines where the previous stitching was to fully secure the window into place. New leather strips were sewn onto the corners. The hood could then be glued to its frame. The vertical bars on the hood frame that is attached to the car had flaking black paint on them. So these were sanded down and then re-painted. The pieces that hold the hood in place at the front and where the front roof panels slot into it, had flaking paint on them too, so these got re-painted in the same manner. The hood could then be attached to the car again. Kath also reglued various pieces of fabric that were coming away around the inside of the TVR.

Share this post
Enjoyed this article by Craig Ranson?
Email Craig Ranson