Sealed up Tight – Replacing the Pinion Seal on the 1967 Ford Mustang Convertible Rear End

Mauro, our in-house restoration technician, has been working on the 1967 Ford Mustang that we have in the Bridge Classic Cars workshop.

As part of its mechanical refresh recently, Mauro replaced the rear axle seals and now it’s time to renew the rear pinion seal. A key part of the well being of any rear-wheel drive car.

After removing the old seal and inspecting the mounting surfaces, Mauro then put the new seal in place and check the pinion worked correctly. It all worked perfectly. So with that, the driveshaft and coupling were put back in place and it was time to move on to the next job on the list…

Share this post
Share on facebook
Share on twitter
Share on pinterest