Take a Seat – Building and Fitting the Seats to the 1970 Dodge Charger

By Craig Ranson
By Craig Ranson

Managing Director – Bridge Classic Cars

Brian is working on the inside of the 1970 Dodge Charger that is in the Bridge Classic Cars in-house trim shop.

Brian has been building up the seats ready to be fitted into the car, both front and rear. Brian built up the rear seats to get into the car to begin with so that each of the other pieces can be put into place. The rear bench seat splits into two pieces so the careful placement of the covers and fixings to make sure all of the patterns lay straight and true to each other.

Then it was time for the front seats. All the side trims for the front seats needed to be fitted in preparation for them to be fitted into the Chargers cabin. All of these pieces were carefully fitted by Brian as to not mark or scuff any of the plastic trims. Then, once all finished and present they were put into the interior of this amazing Muscle Car.

Share this post
Enjoyed this article by Craig Ranson?
Email Craig Ranson